Back Wall and cuddy supports

I was able to get the back wall glassed in this past weekend. We cut our original single piece in two in order to get it in...b/c we had installed the gunnel supports/rod holders since we cut the piece...we cut out three hatch holes to match the one in the floor, so we have easy access to the transom, batteries and switches. We also added some supports to the cuddy, which I cab'd in. I also applied a generous coating of cab to the instrument panel and will be burning up some sanding disks to get that right. Here are the pics:
Back wall, cab'd in at the edges, bottom and top, then a piece of the tape glassed at the edges, top and bottom:

back wall at the connection to the sidewall:

new supports, need sanding: